3D Prints by Our Customers

Share Your BOTFEEDER'S Using the Hashtag #BOTFEEDER and Your Images Could End Up Here

3D Prints from Our Customers

3D Prints by BotFeeder

3D Prints by BotFeeder

Frequently Asked Questions

What are the recommended temperature settings?

Material Hot End Print Bed Min. Layer Thickness Min. Nozzle Size Other Condition(s)
ABS 250-260C 110-120C 0.05mm 0.1mm N/A
PLA 200-220C 66-70C (optional) 0.05mm 0.1mm N/A
NEO-PLA 185-220C 70-80C (optional) 0.05mm 0.1mm N/A
Filasglow 205-225C 70-80C (optional) 0.2mm 0.3mm *CLEAN
Filastic 220-240C 110-120C (optional) 0.2mm 0.3mm *SUPPLE
Filatron 200-220C 65-70C (optional) 0.2mm 0.3mm *CLEAN
ReFilactive 230-240C 70-80C (optional) 0.2mm 0.4mm *SUPPLE

*Clean Nozzle

Some materials are very aggressive and will wear your nozzle over time. It is suggested to clean your nozzle tip after every print to maintain your printer at top condition. This apply to Filaglow and Filatron.

*Supple Material

Since the material itself is supple, it is therefore recommended to have the printer built with the stepper motor directly above the tube. This allows the material to exert its maximum thrust as the motor draws it in. The gap between the feeder gear and the tube should be minimal at best (< 5mm is recommended), and the diameter of the tube should be as close as possible to 1.85mm. Also be aware that the feeder gear should not squeeze too tight. Having just enough force to draw in the material will suffice. It is of utter importance that the nozzle and the heated bed are kept at a distance as the preliminary layer is extruding. Failing to do so may result in bending of the material due to excessive resistance, and render the material unable to be drawn into the feeder successfully. When the print is complete, allow the heated bed to cool down prior to removing the print. Attempting to remove the print while the temperature remains moderately high may cause distortions to the print.


Storing Your Filaments

Please note that improper storage may damage your filament. To maintain its original quality, it's strongly recommended that the filament be stored in the following conditions: 1) A dehumidifier cabinet or a dry and circulated area; 2) Room temperature; and 3) Avoid direct sunlight or heat source.


Avoid Tangling Your Filament

When unpacking, changing filament or unloading, It is strongly suggested to get a good grip at the end of the filament at all times in order to prevent tangling. The spool holder is specifically designed with 2 holes of each side, allowing you to secure the end of the filament by threading into it. or you can simply 3D print a "Filament clip" that is attached to the spool holder itself.


If Filament Gets Damp

Dry it slowly in room temperature. Please note that heat drying the filament will damages its quality by making it become brittle. The preferred method of drying your filament is to put in a dehumidifier cabinet or in an airtight bag with a few packs of desiccants. It's recommended to maintain a humidity level of 25% or less.